ingeborgdot
i have 3.2 w/o any voltage increasing. I think it's too low frequency to raise voltage.
why I have to run 1.53v to get stable at 3.5
Obviously, the unsuccessful processor. What VID it has? Anything more than 1.275v do not reach greater results, on my supervision.
Does anyone knows what is the difference plugging single 4-pin power and 8-pin power
8pin allows to unload a little PSU and to raise stability as two lines of a 12V are used.
Now what is the best thing to test stability
The best heating - Linpack.
Prime - smallFFt.
OCCT.
If errors are not present - all stably.