LianLi PC 343 Cube Build Thread

[TopherTony]

Ok guys, its finally time. I made it back to the states on leave just fine from Iraq. So now I can start. I Have all of the materials I have amassed while away, and everything is here, minus a few small things, but those are getting worked out. I am sorry to keep you all waiting but here we go.

Compressor: Tecumseh AKA9455zxa r404a commercial low temp
Condenser: Water Cooled HX
Metering Device: Emerson Controls CPEV
Evap: Gosmeyer's Cryostar
Extras: Tube in Tube SLHX, Accumulator, Receiver, 6'x1/8" feeder line, Cube Case











I have also decided that I will not be doing 2 seperate phase systems. I simply do not have enough space for the filter driers and the receivers with two compressors in side. Instead I will have a full water cooling setup. A loop for the condenser of the phase. And a loop for the water blocks, NB, SB, MOSFETS. And maybe a third later on when I decided on GPUs.

Also, I need the rubber mounting feet that goes on the base of the compressor. Where can I get some? I have Johnstone supply kind of near me that I was at yesterday, but its a pretty long haul. And I would rather pay online shipping than in-route gasoline.

UPDATE: 12/31/07

Ok, here's the latest photos































Next step is to go back to the hardware store to get more hose clamps. I thought 20 was enough for this. I need 8 more.

Gotta add more eye candy to this as well. Tomorrow I fire up the qx6700 B3