I am at 1.42v..bios reads 1.44...best I can seem to do is less than 400fsb

If I set for 1.48v..bios reads 1.5v(I know the bios may not be accurate but what else do I have to know for sure)..so to me 1.48v bios setting puts me at the 1.5v limit..too close for comfort(what if the bios is wrong and I am getting more than 1.5v and the board dies..I payed way too much..so I am out of optios as I see it)

I do not want more than 1.5v...I have no desire to fry the board..I will give up speed for longevity(relative..I do not plan to keep this for yrs)

I would love to run a lower multiplier at as close to 450 as Tony says 464 is best

also they touted this board as top end, excellent performance

1T is not easily obtained....I can get it at 400mhz(not 3D mark05 stable but 12hrs + p95 stable) but not 500mhz..too much stress

the there have been numerous issue with thermal paste on chipset and poor quality HS flatness