Abit AW9D-MAX, vcore mod needed

[crotale]

I can verify that the vcore mod is working.

Here is also a read out for the vmch, along with a vmch booster mod. (either ends of the thick wire)
The booster mod is engineered by Hipro, all credit goes to him!

[shimmishim]

I can verify that the vcore mod is working.

Here is also a read out for the vmch, along with a vmch booster mod. (either ends of the thick wire)
The booster mod is engineered by Hipro, all credit goes to him!

I assume the smaller wire is going to something you have setup so you can read the vmch voltage w/o having to flip over the board. Am I correct?

[Digerati]

I can verify that the vcore mod is working.

Here is also a read out for the vmch, along with a vmch booster mod. (either ends of the thick wire)
The booster mod is engineered by Hipro, all credit goes to him!

I'm new to the modding scene. I'm just wondering what kind of wire that is, I've decided to finally put my soldering iron to good work but I'm still in awe of all the info out there.

[crotale]

I'm new to the modding scene. I'm just wondering what kind of wire that is, I've decided to finally put my soldering iron to good work but I'm still in awe of all the info out there.

That specific one is just a wire from an MOLEX -> SATA power cable, but any one will do... The thicker the better.

[SilveradoJ442]

Success! Booster mod and Vfsb mod. This was my first time modding a board. Booster was very simple. Its been a while since I soldered but I think they came out OK. There is a little too much bare wire showing but it should be ok. Vfsb mod was a little scary but after reading Thrilla's awesome guide I was a little more confident. Now I just need to find the sweet spot and finally let this e6700 run wild

If anyone was wondering, not only can you use the read point for voltage, but GURU also has Vfsb labeled as "CPU VTT 1.2 Voltage"

And a few pics





Anyone know the safe range for voltage? GURU starts buzzing at 1.45v which is like 1.39-1.4 actual. Thanks for the guides great work!

[shark2]

vdimm and vmch / chipset mods for AW9:

vdimm:


......cut......

Both mods will give approx. +0.1V when soldered in.

I have tried them both myself

guys,
I would have need to arrive to 3V max on the vdimm, it's possible with this mod or could be of the problems?....which is the max sure voltage that i can set with this mod?

thanks and sorry for English