Hey Guys!

The testing went very well but the Cryo-Z socket assembly inside the tight spaces is VERY tricky! I had to do it 4 times before hitting the jackpot.

The temps raise and the evap can't stabilize if it's a tiny bit off the center.
But with a good assembly it's all good:

On idle it's holding the Quad9650 @ 4049Mhz with -46 according to Smartguardian

IDLE:


Full Linpack Load (wont get hotter then this) held the Quad @ - 25 to -21:


The watercooling seams to be working as it should too, North Bridge and PWM area won't pass 35oC and the HOT Radeon's 3870 are idling 37oC with all the Fans in Silent Mode (Yate's Medium speed with 7v). Before this upgrade 55-60-79!

I can't upload the final pics yet it's too late and I'm tired and more testing will be done when I finish the Q9650 burn-in.