Vince this may sound like a stupid question but does it matter how the pot sits on the cpu. Don't think i worded it so well so would one of the following positions work better then the other
Vince this may sound like a stupid question but does it matter how the pot sits on the cpu. Don't think i worded it so well so would one of the following positions work better then the other
Originally Posted by Cpt Twitchy
Nope cpt. The base is tuned for a certain ammount of surface area period, orientation over the chip is not that important. I have benched it diff ways, but usually the letter are going left to right towards the top of the board. I am pretty superstitious
Good luck with your pot DPA..
The base is not really clear in the pictures. I am willing to bet that there is more copper underneath the letters on this pot, than just about most other pots. Not that this makes my pot better or anything, thats just how this one is. It was tuned for 5400mhz+ quad/06 four cores. Some measurements I really dont want to give out for obvious reasons, especially publicly.
Last edited by k|ngp|n; 11-04-2007 at 08:01 AM.
Nope cpt. The base is tuned for a certain ammount of surface area period, orientation over the chip is not that important. I have benched it diff ways, but usually the letter are going left to right towards the top of the board. I am pretty superstitious
Good luck with your pot DPA..
The base is not really clear in the pictures. I am willing to bet that there is more copper underneath the letters on this pot, than just about most other pots. Not that this makes my pot better or anything, thats just how this one is. It was tuned for 5400mhz+ quad. Some measurements I really dont want to give out for obvious reasons, especially publicly.
Hey!
Hehe, your pot seems like _the_ pot... I just have to try then, hehe
Make a thread with your 3way SLI maybe.. thatseems awesome...!
Posting Permissions
Reply With Quote
Bookmarks