I sure do love my BH-5!!!

[Orian]

Had the chance to use stang_man's power supply with a modded 3.3v rail. (3.6v/5.1v/12.2v) on my droop/vdimm modded P4C.

3.4vdimm yielded these results...



What is max vdimm I should run? I only stopped at 3.4vdimm for fear of frying the ram.

[afireinside]

I talked to Jason when I was thinking of getting an A64 rig and he said 3.6 would be ok fo benching. I'd feel safe shoving 3.7V at it for an hour of super pi

Nice OC BTW

[Stang_Man]

we're scared to pump more than 3.4 vdimm through these sticks..

we didn't notice much of a difference between 3.3V and 3.4V though..

[Gef]

Are they stable at this speed and volt?

[Orian]

We didn't have enough time to test them for stability, but they did do 270mhz for a minute, then locked.

[Gef]

Originally posted by Orian
We didn't have enough time to test them for stability, but they did do 270mhz for a minute, then locked.

With my XMS3200LL rev 1,1 i can boot up and do some tests with 260MHz 3,2v

[afireinside]

Common go for 3.6V

[macci]

Nice going

BH5 is sooo NICE

[Garrett]

Please send me some Macci, my CH5 craps out on me and will NOT do 5-2-2-2

[computerpro3]

How many volts did that take, macci? I think I may have a shot at getting there as I can do 265 2-2-2-5 @ 3.3v so if I shove 3.6 through these babies...

[TheWeaseL]

I'd put 4v down it for benching if I had the mod to do it...