Abit MAX3 V-Mem mod? any one knows?

[gabbax]

3.2v is to low must get 3.3--> my BH-5 TwinMOS/Winbond can do 244@ 1:1. but to get higher, u have to help me. il att some Pic here, and if anyone could paint where i should do the jod, i be verry pleased



//Gabbax....

[LiMPAN]

anyone? :/

hipro?

[CATCH22ATPLAY]

Remove MC64 and in it's place put a 50k ohm vario resistor. Try 50k ohms to start. I can't be bothered atm to do the math. But to be safe i suggest you set the ddr volts in bios to 2.65 or whatever default is. I think 40k would give you about a 0.055 volt increase. 30k ohm 0.073 increase. 20k ohm 0.108 volt increase. 10k ohm 0.20 volt increase. But please try the 50k ohm first. Then once you check it with ddr set to 2.65 in the bios see what it says in the bios. Then bump up the volts in the bios and check again. Keep doing that til you get to 3.2v setting in the bios and see wtf you get there. Check and see if my math was semi close to correct. I haven't tried doing this mod. But it should be perfect imo.

[CATCH22ATPLAY]

ACtually it would probably be more helpful doing a VTT mod.