Results 1 to 4 of 4

Thread: Having some probs with Winchester 3000/DFI NF4 Ultra-D

  1. 02-04-2005, 11:22 PM #1
    wicktron
    wicktron is offline
    Xtreme Member
    Join Date
    Nov 2002
    Location
    Floss Angeles
    Posts
    121

    cancel

    cancel
    Last edited by wicktron; 02-07-2005 at 10:46 PM. Reason: delete
    Reply With Quote Reply With Quote
  2. 02-04-2005, 11:32 PM #2
    Zedex
    Zedex is offline
    Xtreme Member
    Join Date
    Jan 2005
    Location
    UK
    Posts
    113
    Could be the CPU's memory controller. There's a lot of problems cropping up over Winchester's memory controller. Seems only a few Winnies actually OC much more than 2.4-2.5GHz. Try flashing to the most current BIOS for your mobo. Also I recall reading somewhere on this forum and also on DFI-Street that using the 20-24 pin convertor wasn't a good idea. They said to use a proper ATX 2.1 PSU, not sure if that was just in regards to using SLI though. If there's still no joy after trying all that, then I'm sorry to tell you, but you probably have a winnie with a bad controller. I can't think of much else.
    Reply With Quote Reply With Quote
  3. 02-05-2005, 12:54 AM #3
    Super strokey
    Super strokey is offline
    Xtreme Enthusiast
    Join Date
    May 2003
    Location
    Edmonton Alberta
    Posts
    955
    what is your htt multi at?
    Reply With Quote Reply With Quote
  4. 02-05-2005, 01:02 AM #4
    quicksilverXP
    quicksilverXP is offline
    Xtreme Enthusiast
    Join Date
    May 2003
    Posts
    660
    I didn't have luck with week 43... it probably is your CPU. Week 40, 41, and 48 seem to be the best.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules