I received this motherboard this night from Biostar and I haven't test this board much yet but I'm really impressed with Tpower X58 , everyone wants high fsb and stable,don't doubt, this X58 is really good so far ^^
I can get into windows at 215 with low voltages but i can not reach more than 217 ,wrong settings maybe ,i need to tweak a bit more ^^
Here a quick run on air
Wprime 32/1024 @ 4450MHz
Pifast/winrar @ 4500MHz
SuperPi-Sandra @ 5520MHz
3d(HD4870X2 @ 840/1000MHz)
3d05 @ 4450MHz
3d06 @ 4450MHz
youtube -> 3d06
http://jp.youtube.com/watch?v=yA6mF7yC1x0
Retail Core I7 920 (Thermalright Ultra 120 Extreme 1366)
Biostar Tpower X58
3 x 1gb Adata 1600MHz
HD4870X2 (840/1000MHz)
Thermalright Ultra 120 Extreme 1366 + San Ace 102CFM
Room Temp @ 15c
Intel SpeedStep Tech - Disabled
Ratio CMOS Setting - 21
CPU Frequency Setting - 200
QPI Link Speed - Full Speed
DRAM Frequency - 1600MHz
Command Rate - 1T
>Intel PPM/Turbo Mode Configuration
Intel SpeedStep - Disabled
Intel C-State tech - Disabled
>DRAM Timing Configuration
Ch A/B/C DRAM Misc Timing - SPD
DRAM Timing Control - SPD
>Clock Gen Configuration
PCIE Clock by - Manual
PCIE Frequency Setting - 100
CPU Clock delay - No delay
MHC Clock delay - No delay
>All Voltage Configuration
CPU Vcore - +0.300v
CPU VTT - Auto (1.408v)
CPU PLL - Auto
DRAM Voltage - 1.84v
NB VCC - Auto (1.104v)
SB VCC - Auto
QPI/PCIE PLL - Auto
LN2 soon
Bookmarks