CellShock 1800 GTR Don't want boot on Rampage II Extreme

[hiwa]

Hey everyone

I have 6 moduls of Cellshock 1800 8-7-6-21 1.9 and they don't want boot on RampagII extreme

i tested Gigabyte EX58 Extreme and no had problem with this moduls but REX2 can't boot them

anyone have some old SPD of Cellshock 1800 ?
tried boot with crucial 12800GTS and put Vdimm to 1.9/2.0 save profile and exit
restart and tried with CS but same there no boot at all

tried Reference DDR3 Micron SPD and did'nt boot
http://www.xtremesystems.org/forums/...d.php?t=190793

so i need



i need 1066MHz 7-7-7-21 Cellshock SPD if someone have this SPD please share here

here is actual SPD


Thanks

[dread77]

Did you try with three dimms? I booted just fine with two Cellshock 1800 GTR and one Dominator 1800 GTR 8-8-8-24.

[CryptiK]

Perhaps try each CS stick on its own, maybe there is a dead stick.

[hiwa]

Did you try with three dimms? I booted just fine with two Cellshock 1800 GTR and one Dominator 1800 GTR 8-8-8-24.

yes dual channed detected


bios 0602

[hiwa]

Perhaps try each CS stick on its own, maybe there is a dead stick.

they are working perfect @ gigabyte

[frank.lopez]

What voltage are u using?

I've seen in a review:

The Good
• Managed DDR3-1922 on stock timings and DDR3-1964 on slightly relaxed 8-8-8-25 timings.
• Worked perfectly out of the box with only 1.7v
• Cheaper than a lot of DDR3-1800+ kits on the market.
• High quality heatspreaders.
• Thermal paste used between memory and heatspreaders for maximum transfer of heat.

The Mediocre
• Didn't like voltages higher than 1.8-1.85v
• Benchmark results just a tad lower than the Patriot kit used for comparison.

The Bad
• Absolutely nothing!

Try to boot them at 1,7v

See the full review Here.

[hiwa]

thanks frank.lopez i tested them on Gigabyte and no have problem for triple channel @ 2.04 Vdimm
overclock3d tested this moduls on Q6600 not I7, i had problem (when i had REX2)on new I7 and just Triple channel tried flash them to old 8500 Spd's and just got error