Straight to the point ,today we tried so hard to reach the magical 6.0 barrier with our E3110 but we had no luck ,that Xeon is only good for 5909-5928Mhz(5950Mhz with no validation)
so I have decided to change the cpu for an E8500 Q807 ...
I'd started getting success with the Wolfdale I was running low on LN2 and so didn't manage to do a complete run of 3d tests ,anyway we just joined the Big 6
nice mobo, nice cpu and great job by Yoko/Nozomi
CPU - Xeon E3110 QQ750A + E8500 Q807A
Pot - Chilly1 LN2/Dice Conteiner + LN2
MB - Biostar with no mods and stock cooling
Ram - Team Group 1066 1024mb x 1
VGA - HD4870 x 2
PSU - Giga-EZ 1000w
Bios
Over-Clocking Navigator [Manual OverClock]
Intel(R) SpeedStep(tm) : Disabled
Ratio CMOS Setting : ×9 - x9.5
CPU Frequency Setting : 580
Over Clock Retry Count : 2
FSB Finetune : Enable
FSB(Bsel) To NorthBridge Latch : 1333
DRAM Frequency : DDR2-1160
DDR2 Enhance Mode : Disabled
DRAM Timing Configuration
DDR2 RCOMP Configuration : 2
Configure DRAM Timing by SPD : enable (5-5-5-15)
Clock Gen Configuration
PCIE Frequency Setting : 100
CPU Clock Skew Control : 200ps
(G)MCH Clock Skew Control : Auto
CPU Clock Driving Control : Auto












Reply With Quote











Bookmarks