I already did my Vc, but am looking at doing PLL voltage as well since it really seems to be the only thing getting me past a certain point. From the digging I've done, it looks like the P5K Deluxe is the same overall layout and same basic ICs (although different manufacturers) and that's where I picked up the the PLL and FSB read points from.

I was all set to start soldering, but I wanted to verify that the measure points were the same as the Deluxe first and my results seem to indicate they are not, unless I am totally missing something.

The fets/resistors are in the same locations as the Deluxe and they "seem" like they could be the correct measure points as marked (Vmch SMT is definitely a correct read point), but I have odd results on the FET legs for the other 2. FSB & PLL voltages measured at those points don't change with different settings in BIOS, so I am not 100% these are correct on the Prem or if I am missing something else. As you can see by the fingerprints all over the board, I was digging around pretty good looking for alternate measure points, but haven't found any yet. So, I am looking for some confirmation from anyone who has done the mods and/or measured the PLL/FSB VTT on a Premium.

Just FYI, when I check the "Vfsb measure" leg, I get 1.06V no matter what FSB Term is set to in BIOS. When I check "Vpll measure", I get 1.548V no matter PLL Voltage is set to in BIOS.



Any help on this is appreciated...and I am sure not from just me