OMG dino thank you so much!
Hey dino, is there something im missing? The vcore can go up to 2.1 but im still locked at 1.49v for the VTT.
Same for me with the Filefactory-Downloadlink. Anyone got 0.2 Volts for me?
Btw, thanks for your effort dinos!
Hey dinos, any news on this.
Still only seems to allow 1.49v VTT.
sorry no replies yet![]()
Kk, thanks a lot man. I appreciate the help.
Out of curiosity though, why didn't GB support higher volts to begin with?
i dont know im guessing they thought there was no point as they are low end boards and not really meant for xtreme OC in first place![]()
OverShocked
High VTT is NOT a good idea & doesn't help much. It only makes the IMC cold bug even worse......and it kills
I supposed Cookie was also aware of this
With a good 530 & OCP mod, -160c can be easily obtained
For higher BCLK, it all depends on the chip
I had tried dozens, only a few could do 280+ BCLK boot up into Windows & reach 6.7+ GHz
The Bios setting is simple:-
Vcore: 1.88v
VTT: 1.41v
PLL: 1.8v
PCH: 1.34v
Others: Auto
Hope it helps![]()
A qualified amateur has been poisoned by LN2 & soon be killed
can you share the mod with everyone please
let's get this party started lol
Thanks a ton mad222, cant wait for the mod!
At what point did you have troubles before ocp?
The chip I was playing with didnt like the cold as much as it liked the volts... Between -110 and -140 i could only get like 2 more bclock out of it, so I raised the vtt and that helped a lot.
And I love you for the bios settings m8.
One question though, what do you usually set the clock generators at?
I found that 700 for cpu and 800 for pci was better for me. Any insight?
Thanks!
Teamwork makes dreamwork guys. (:
Last edited by OverShocked; 07-11-2010 at 10:11 AM.
dont give up all your secrets mad hehe
afterall you did put a lot of effort into it...that's what makes it fun....getting there right![]()
IMC coldbug with high vtt ?i think u mean IMC coldbug with high qpilink
![]()
if this little board can run +300 with high qpilink with just 1.41 VTT i think gbt should change layout and sell it like P55-UD9![]()
got another 2 chips here same batch this timewill test again in weekend
![]()
^Same thing happens on some 980x's. Me and bodar were testing one that didnt have a coldbug at stock volts, but once you gave it a lot of VTT (its max IIRC) the CB became -140.
not sure what board you used but i've seen the opposite with 980X
at least all the CPUs i tested on the UD9. You can use VTT to push cold bug lower basically
I had the same problem with some 980x on UD7 as well
Need to advice Mr. Cookie, but he might be busy watching FIFA
Good luck...guys !
Problem solving is fun![]()
A qualified amateur has been poisoned by LN2 & soon be killed
thing with IMCs is they will only take so much volts
what i would suggest is maybe trying to find volt limts for IMC but keep in mind that a lot of guys say retail CPUs die easier with over 1.5 VTT (gbt tends to undervolt VTT a bit so you may be able to use more but measure it under the socket)
it also depends on type of RAM, spd and pcb
Bookmarks