DFI rev b vcore and vdd mods

[soki]

vsense (VSEN) is PIN 10 on the same chip (HIP6301). So instead to solder only -> : PIN 7->50 Kohm trimmer-> ground : , you repeat the process another time -> : PIN 10->50 Kohm trimmer-> ground :
. So you must to do 2 complete mods for the vcore. Check this also. http://forums.extremeoverclocking.co...c/21990-1.html ""If you are using an AMD rig and are going super high and the system cuts off on you, you will need to start lowering the resistance of the other resistor (@VSENSE ) to "fool" the over voltage protection. You will just have to fiddle with it since it's not an exact science. ""