My 3.3 drop like a brick on this ttgi when OCing. cpu @ stock im @ 3.28v on my 3.3
Cranking up to my sig 24/7 specs, then starting F@H 2 instances.
Looking @ my 3.3v then and then my mem volts drop accordingly!!!
Im using the one from our main page review 4 fans, 3 settings.
ttgi 550 clickie
If i wanna do any benching, i've been hooking up a second cheap fortron to the MB with the 3.3v upped to 3.7.
I like this TTGI because it does flow a lot of air out of my case. but this bad drop on the 3.3 is unacceptable under load. inside is one pot for the 5v and 12 single. No volt sense line at all.
My BH ram loves 3.5v and will do 260+fsb 1:1 tight timings.
Anyone else having this problem with the supply?? Or probably im just asking too much of it!!!! Im about to just run dual supplys or a big fortron.
Reply With Quote
Bookmarks