Finished? er yes and no. Yes in that it works fine. No in that i'm gonna change it a bit later on. But here it is. The first 4 pics basically show you where to cut the trace. Look at my arrow and you will see a trace by itself that goes up and to the right. Cut that one. Then ohm out from bottom leg of upper right mosfet on mobo to left side of MC50. It was 1 ohm and should be reading say 5 mega ohms now. I then solder a 500 ohm vario set at 320 ohms to left side of MC50 and bottom leg of mosfet located in upper right corner. Then i used a second vario connected to my first. Connect it to the first Varios side that connected to MC50. Then connect other side of second vario to ground. I used a 2k ohm vario and had it set to 2k ohms for a 0.20 increase in VTT. I had my bios set at 2.80 I increased VDD to 3.2 with my VDD mod. The VTT mod came to 1.60 with the 500 and 2k ohm resistors. Sorry about the webcam. I hope this helps. Winbond will read volts as 1.40 btw. So use a multimeter on upper mosfets to check voltage.
Volt modded the CATCH22 way
I removed MC50 completely. Also if you remove MC64 it really helps VDD mod a lot. I was able to increase VDD and VTT to 3.4 and 1.7 with theese mods on my non max3. It had no problems booting at all. Luck dudes and i'm ready for questions. Also did the mod on my max3.
Reply With Quote
Bookmarks