Watercooling case design I wish I could make.

[MadHacker]

Who knows how to get sponsored? I would love a few rads to get started with.

If you build it they will come.

[ohms]

Nice creation there Power5, I like the way it looks It sure is sexy.

Good luck with finding a sponsor.

[Power5]

Poor attempt at a lighted rendering. Not an expert at 3dsMax by any means. Added a hot swap to the front. Probably swap the placement of that and the DVD since this will be on the ground and not desk level. Though, not sure which would be better suited up top. Only about 200mm difference in height though.

[LeandroJVarini]

wow, nice,

[Gone Cruising]

This is what im currently using for my removable mobo trays on some of the cases:

http://www.brunnerent.com/Tools/Port...=6&strMetaTag=

I can't find this "F" channel anywhere else though. It would be a lot cheaper if it weren't already anodized. I did find aluminum angle is dirt cheap at Lowes.

I've posted my cases at the EVGA forums if you want to get some ideas..maybe I should post a thread here??? I think I will to get some feedback.
It took me about six months to configure the aluminum angle cutting, drill holes..etc... many many sketch up drawings tossed out...LOL!!!

[Power5]

Yeah, checked out evga site, but only saw like 4 photos.

How exactly do you use that "F" channel? Like a runner that the tray slides in?

[Herbal]

Nice looking case Power5.....keep up the good work!