Is this much heat normal for an FX-55 San Diego?

[kiwi]

Temps are too high. My Sandy never went above 49C on air full load overclocked. Do you have antarctica cpu block?


I remember I had Asetek waterchill and my temps were initially really high because water somehow was blocked in radiator. I reassembled the water system, moved radiator up and down and it was fine after that. Not sure if that is in your case. Also you using AS5?

[madpete]

Temps are too high. My Sandy never went above 49C on air full load overclocked. Do you have antarctica cpu block?


I remember I had Asetek waterchill and my temps were initially really high because water somehow was blocked in radiator. I reassembled the water system, moved radiator up and down and it was fine after that. Not sure if that is in your case. Also you using AS5?

Hi yeah using Antarctica waterblock, I will try that with the rad. Where you getting any noise when you had the block cause I'm silent?

Oh and I always use AS5.