P4C800 E Deluxe Vcore mod, Vdrop mod, Vmem mod.

[Malves]

Are these mods valid for a Asus p4p800 deluxe.
Thanks

Go here. Please, note that for the droop mod on the P4P800 has changed after Asus made a revision on it. Do a search here for it, and you'll find the other way to do it, if your revision is different than the one on that site.

[deltarealm]

Does increasing the 3.3v rail effect the temps of the mosfets?

[muzwa kai]

hello everyone. im new here. this looks like a great forum for modding, so i registered.
i am in dire need of the vcore mod on my p4p800 e deluxe. ive done vdroop and vdimm, and they both work excellently.
i attempted the vcore mod by soldering a VR to pin 8 (fb) and ground on the ADP3180 IC, but had no impact on my vcore. ive never seen anyone actually say that it works on their p4p800 e dlx. apart from the p4c800 dlx, i dont know of any mobo that has the same ADP3180 IC. any help on this matter would be greatly appreciated.
is there perhaps a very fine line in the VR adjustment that enables vcore change. the volts stayed the same for me as i reduced the resistance toward 0K, but got to a point where the screen goes blank and wont reboot till up the resistance a little.

[Kin Hell]

Go here. Please, note that for the droop mod on the P4P800 has changed after Asus made a revision on it. Do a search here for it, and you'll find the other way to do it, if your revision is different than the one on that site.

Hi Malves,

I'm using a bog std P4C800E Deluxe. VCore is set at 1.5375v at 246fsb on my 2.8C yet Probe sez its 1.6/1.616v idle!?

Using 1021bios, but all bios versions appear to give same readings!

Wondered if this is Winbond borking it up but value your thoughts on the matter. Thanks!

[AKURA]

DOnt worry bout it. It overvolts by default to begin with and no fix for that.

[Kin Hell]

DOnt worry bout it. It overvolts by default to begin with and no fix for that.

Thanks Akura.