help me for mod vcore asus k8n-e

[persivore]

Connecting pins 17 and 18 via a variable resistor should reduce the droop. How low did you decrease the resistance?

[Poy]

. How low did you decrease the resistance?

i don't understand , what is "low"?

with this method of pin 17 and 18, it will be better?

I'm not sure about this, but try connecting a varable resistor between pin 17 and ground for the droop mod.

with this last sentence:


pin 17 = 2.0V
pin 18 = 1.9V
with a resistance of 10k on the pin 17 to the ground, the voltage of the pin 18 jump to 2.3V. is it good or not?

[persivore]

i don't understand , what is "low"?

with this method of pin 17 and 18, it will be better?





with this last sentence:


pin 17 = 2.0V
pin 18 = 1.9V
with a resistance of 10k on the pin 17 to the ground, the voltage of the pin 18 jump to 2.3V. is it good or not?

Did you try conencting a varaible resistor between pins 17 and 18? You will probably need to set the variable resistor to about 28k for the droop mod to be the most effective.