--- Stevil ---

If you ever saw my "non-quick" looks, you would understand


--- Eva ---

Their original target price was quoted in the low 400s range US$. As a result of demand (mainly OEMs) it started off mid 400s, but I would expect after the initial "rush" is over, it'll go back down.


--- Hombre ---

Thanks The comment about the 12V rails wasn't a mod request by me... it was a query of them on how the rails were allocated in the stock units


--- GazC ---

Having previously read about your probs with their support, I can understand your point and sorry to hear of them. Maybe you can start a poll about it

Regarding my "luck"... as you might notice in one of the pics, this isn't the first PCPnC PS I've owned. I've never had an issue with their support or in getting a response from them... like I have with others. Regardless of how many Qs I've asked or what I've requested over the years, they have always been helpful and in the case of emails, responded within 2 days. Maybe it's because of how I ask/request... or maybe it's because I'm in the US. Don't know the why, but my experiences have always been positive in that regard as well. Isn't because I'm a "regular" customer either... my PS purchases tend to be spaced out quite a bit. Isn't because I'm a "homer" either... in fact as I said up front, I was looking elsewhere this time because they didn't have what I needed at the time and had I had luck elsewhere, would have gone another way. Then again, I've got a DFI SLI-DR that has been "stretched" for over a month now without any problems in the least and.... nm, I won't bore you... so maybe I do simply have "good luck"


--- shadowing ---

Previous experience, both mine and others I've talked with, has been basically this regarding customization - "What do you want, here is what it would cost and how long it will take." The only limitations I've experienced before is, "Can't do that because of Agency XYZ regulations" and "that would require a complete redesign." There have been some on XtremeSystems that have had "remote" trim pots added to their supplies (on the end of long cables for mounting on front panel of chassis) for example.

In the case of this PS in particular, they have a very high OEM demand at the moment and they are in "catch-up-mode" making them, so time frames may be a bit longer than usual. Any of their other units, they typically turn customizations in less than a week.