MEMORY Voltage Scaling, please contribute...

[EnJoY]

Rabbi, with your 3.3v rail at it's current setting, with the 4.0vdimm bios you should be able to get 3.4-3.5volts. Why aren't you doing that?

[Rabbi_NZ]

Rabbi, with your 3.3v rail at it's current setting, with the 4.0vdimm bios you should be able to get 3.4-3.5volts. Why aren't you doing that?

My 3.3vRail = 3.6v with DMM when not loaded... in Smart Gaudian software it is actually read at 3.47v-3.5v... and Im pretty sure the 3.3vRail needs to be at least 1.5v higher than the vDimm.
I tried running it at 3.4v and it was only at that level unloaded... in Sisoft sandra it actually dropped to 3.3v so my 3.3vRail needs to be cranked up to get anymore vDimm, and I dont want to mod this PSU.

Rabbi, with your 3.3v rail at it's current setting, with the 4.0vdimm bios you should be able to get 3.4-3.5volts. Why aren't you doing oh you getting nice 260 with only 3.3v ?

that is great... CPC on ? 1T ?

Did anyone get any decent ocing with them on DFI NF2 ?that?

1T 2-2-2-10-7-15 3.3v

[EnJoY]

I had mine on my OCZ upt o 3.8, I suggest you try that and set it to 3.4volts. If that doesn't work, somethings wrong with your board.

[Rabbi_NZ]

I had mine on my OCZ upt o 3.8, I suggest you try that and set it to 3.4volts. If that doesn't work, somethings wrong with your board.

My 3.3vRail = 3.6v with DMM when not loaded... ...my 3.3vRail needs to be cranked up to get anymore vDimm, and I dont want to mod this PSU.

...