Let's see the X800XL 3D screenies!!!!

[charlie]

I have been following this thread, hoping that some of the guys that have succesfully voltmodded their X800XL would make some sort of guide. Take some pictures of how how they did it.

I have seen this page http://www.techpowerup.com/articles/...g/voltmods/112
but drawing with a 2B pencil to make a bridge on the VGPU and drawing directly on the resistor of the IGPU havent raised the voltage. I measured the voltage at the point they have shown, and it has been 1,408-1,41 before and after I tried to draw.

Am I doing the correct thing? Any help would be good.

Greetz, JayN1

Pencil mods suck...
Do the solder mod. I used a 10K VR, pre-set at 10k one leg of VR to one yellow dot and another leg of VR to the other yellow dot, e-z as pie.

C