They are connected over [ on top of ] existing caps on the board. Look at the backside of your GT and You'll find 20 small caps in 2 rows.Originally Posted by kryptobs2000
Where are these soldered onto at? Same place that the green wire goes, and I could use 3 2200uF 50v and it would work too right? And sorry for asking so many questions, I don't understand how everything works yet, I just kinda do what it says, so I can't interpret things too good, but I'm on my way
One side of those caps reads +1.3V = core voltage, the other side reads 0V = ground.
You solder C2 on top of those caps.
My green caps are C2.
And Yes green wire goes to caps too, the +1.3V side.
1uF is different from 0.01uF, but I'm pretty sure that will work just as fine.
3 2200uF 50v is fine, although You don't need 50V lol.
Use max 5 ohm as R1, if You can't find one, use 2 10 ohm in parallel or 2 8 ohm in parallel.
Oh, and You need 3 heatsinks too. Those power trans / voltage regs can get hot.
But wait 1 more day before actually buying this stuff, I'm about to test a new revised circuit ! Perhaps it's more stable at higher voltage.
Reply With Quote
Bookmarks