Originally posted by phantompunisher
i get 2.97 for a max witchis the same as when im using 3.2 in the modded bios. i belive i have found the problem: http://www.samhop.com.tw/pdf/SDP(B)55N03L.pdf

i have a drain source voltage of 2.98. i belive if this were 3.3 then the full 3.3 would flow through. the mosfet is not fed by the 5 volt line as i once thought. i have run tests from 2.5 -3.2 and taken measure ments at all points of interest. i will do some more investigation. its not for lack of a strong 3.3 line, if this is what the mosfet is run from, because my 3.3 is reading 3.29v
You have to Mod your PSU to get at least 3,5Volts so you can get 3,2Vmem....coz the Mos-Fet "get's" Voltage from the 3,3Volts.....