Quote Originally Posted by Formann
How is the Crucial Ballistix (Micron) compared to the TCCD? I got my booster today, and Speedfan reports a ~0.1v drop loaded. (from 3.3 to 3.21v) My 5v rail is 5.26 idle and 5.25 load. Measured with a DMM.

I have a feeling something is wrong, cause i can do 255 3-3-3-10 with 2.75v, but not a sigle Mhz more with 3.0-3.4vdimm. The only difference is that I can do 245 3-2-2-10 with 3.3vdimm, but only 235 3-2-2 with 2.75vdimm.

Im not done testing, but the preliminary results feels strange.

I had to remove the POT and add two cords, cause it got in the way on my K8NS Ultra-939. With the RAMs at slot 1+2 i could not fit the booster. In slots 3+4 the BallistiX OC poorly.
Not all memory will like the additional voltage. As far as Ballistics they should like volts fine, but the general overclockabilty and yield of the Micron chips has been all over the place. This is why we dropped the EB line with the same chips.

I am not sure that adding wire and attaching the pot that way is such a good idea. Understand that the booster PCB was kept low profile to insure that all of the traces were short. To relocate my pot I bought a Cermet 15 turn 10k pot and soldered that directly on the back side of the booster. Works like a dream with no "sagging".