SuperPi32m 5Ghz Ivy All Out Challenge!

[Hondacity]

its weird that you and charles are having same issues. that ud3h is so tempting!

[BeepBeep2]

sin its rad but i've gotten to the point where I cant even deal with the mvg anymore. ive tried it all and my runs are crap.
i should be in the 6.23 region but something is not happening. I'm about to get a new board. I think Charles is suffering the same as me. there is something in the bios that is just not rocking. my os/tweaks are solid gold. something is holding me back. I'm about to call it on the mvg and get this

dino or anyone know of a matx board that is cheaper I can buy as a replacement for the mvg that will not CB. its all going on ln2 eventually. just think the clarksdale cheap days/ h55m-usb3. what is the equivalent cheapest bang for buck on z77 right now?

zen suggested this:
http://www.newegg.com/Product/Produc...82E16813128544

Hey trans, just wanted to let you know that the top 4 results in this thread were done with an MVG
My ownership with a 2600K will be shortlived...since this little challenge goes until August I'll be ready to play too

[mike]

I think Charles is suffering the same as me. there is something in the bios that is just not rocking. my os/tweaks are solid gold.

Hope you are not suffering from the same stuff as Charles is....


Just running the UD3H for the first time under LN2 right....CBB -110C - and no torch Could be the CPU however which is a complete dud anyways - maybe I should freeze my Hypers?

[dinos22]

lol^


btw, what bclock you on mike?

[gungstar]

no good splave hit me in msn.
sorry my cpuz screen was at mem. its still 50 x 100

do not use cas7 if you can't tight tWCL to 7 or tighter. otherwise cas8 is faster

[owikh84]

owikh84 - 6:26:750 - 50x100 - 1333MHz - 10-12-12-25-107-1 - Asus Maximus V Gene - Team Xtreem 2600C10 2x4GB - 1.68V Air Cooling



Freshly installed MicroXP 0.86 32-bit
No chipset driver, just USB mouse & KB drivers
No AI Suite etc
No wazza
Large Size Cache & NoPageFile registry tweaks
But MemTweakIt is not working

[Raja@ASUS]

sin its rad but i've gotten to the point where I cant even deal with the mvg anymore. ive tried it all and my runs are crap.
i should be in the 6.23 region but something is not happening. I'm about to get a new board. I think Charles is suffering the same as me. there is something in the bios that is just not rocking. my os/tweaks are solid gold. something is holding me back. I'm about to call it on the mvg and get this

dino or anyone know of a matx board that is cheaper I can buy as a replacement for the mvg that will not CB. its all going on ln2 eventually. just think the clarksdale cheap days/ h55m-usb3. what is the equivalent cheapest bang for buck on z77 right now?

zen suggested this:
http://www.newegg.com/Product/Produc...82E16813128544

Drop me a PM with a list of the OS "tweaks" you are using plus UEFI screenshots of CPU config and memory timings (include the timings you are using for the run itself).

What Gungstar said above is correct also. To me this seems like a possible UEFI config error and a combination of incorrect memory timings for the frequency used. Get those wrong and the scores will tank.

[mike]

lol^


btw, what bclock you on mike?

I am on 100 - is it better to be 100 or other? Only managed to pull down temps twice ... both times crashing when trying to run 32m at only 5.5ghz - but stopped - too annoying not ahving anything to heat the pot up ...another try tomorrow!

[dinos22]

yeah 100 will have a worse CBB and CB

try using 105+

[mike]

yeah 100 will have a worse CBB and CB

try using 105+

awesome!! Thanks for the heads up! Too spoiled running cascade with SB....time to get used to play CB again!

[Leeghoofd]

no good splave hit me in msn.
sorry my cpuz screen was at mem. its still 50 x 100

Don't use CAS 7 Trans, it's copy is far lower here than C8... you just need a good ram set for this... my TridentX's ( similar to yours, are the best out of my ram sets. ) but don't go TRCD 12 on air at all. Massman still has the BBSE and the good Samsungs RipjawsZ, but to get sub 20 sec needs mega tweaking and/or chilled dimms...

I also saw you were using 4 cores and HT on, set 2cores and HT off... 1 core is again slower then two...

Leeghoofd - 6:25:594 - 48x102.1 - 1389.5MHz - 11-13-12-18-100-1 - Asus Maximus V Gene - G.Skill TridentX 2666C11 2x4GB - 1.82V Air Cooling

6,25.JPG

No wazaa or nothing, just enter and run...

[Splave]

do you guys accidentally have extreme tweak setting?

[I.nfraR.ed]

I have it enabled, but haven't tried without it.

[massman]

Just fiddling about with the UD3H. The board is really starting to grow on me! :-)

Still some subtimings to tweak. Maybe I'll shoot for a 1400mhz run first.

[Hondacity]

-updated

*the Belgians have landed!

[trans am]

I tried cas 7 and 8. these are psc im on right now. shamino said to enable cstate package support.
I appreciate all the help guys. Its going to take a while to try all these settings and report back. I'm so tired from being up last night. I need a 2nd wind.

[mike]

yeah 100 will have a worse CBB and CB

try using 105+

Hmmm - what's CBB again?

[trans am]

^^ thats unbelievable!

[dinos22]

Hmmm - what's CBB again?

damn

[mike]

^^ thats unbelievable!

you referring to the great job on my insulation?

damn

Yeah! Had to leave my place to get a torch and then didn't need it anymore!!!

[Hondacity]

hey mike i have spare torches. i can send you one

[I.nfraR.ed]

I need better memory

I.nfraR.ed - 6:19:719 - 50x100 - 1300MHz - 9-11-8-22-72-1 - Asus Maximus V Gene - G.Skill Trident 16000CL9 2x2GB/BBSE - 1.84V Air Cooling

2012-05-26 12.24.35.jpg

[Leeghoofd]

Good job Infra.red, at least I'm the fastest with C11 :p

[dinos22]

Or you can try freeze them infra, maybe it will help

[owikh84]

owikh84 - 6:22.687 - 48x104.2 - 1389.5MHz - 10-12-12-21-128-1 - Asus Maximus V Gene - Team Xtreem 2600C10 2x4GB - 1.87V Air Cooling