Swiftech Komodo HD7970 Preview

[gabe]

This is a very nice build!

@Gabe...
What is the exact length of the tube-bridge used between the 2 blocks?
Have you measured perhaps what is the minimum flow required for the komodo blocks to operte efficiently?

I ask these 2 questions, because eventhough i love and will try the parallel bridge X2, i am concerned about the split flow, that might not bit sufficient. In such case i will have to use a single-series bridge

PS: (My order is currently being processed by customs)

exact length:



Flow: see post here

I did this with parallel setup.

[ElGreco]

After seing the build for second time i realized its parallel config but still i cannot see in the post you mention the minimum flow required for the blocks to work efficiently (ml/min)
Also, i certainly know about the Lck Seal male to male conector, but since i made the mistake not to order a couple from you, and currently its not available in Europe , i need an alternative solution, if the parallel bridge does not work as expected with my limited flow. In that case i need to know the exact length of the bridge tube required and not the adjustable length of lock seal that would be definately the best solution...