Sorry for replying so late I'm not well-read in Linux enough to give the details on dependencies, though Refic is a master For the permissions commands, it is recommended to do them even if you don't have any archiving failures right now but as a preventative measure.
Here are the steps:
1. Open the folder in which the node resides(where the .exe's are and the misc. folders - Data, logs, etc)
2. Open a command window within that folder.
3. Type in the following commands(file names are case sensitive) and press enter after each one(you may be asked for administrator password, type pw in at prompt and hit enter again)
Code:
chmod u+x MJ12nodeMono.exe
chmod u+x MJ12barMono.exe
Now exit out of that command window and open the folder called "tmp". Open a command window in that folder and enter these commands:
Code:
chmod u+x bar.tmp
chmod u+x bar_pro.tmp
Note: the second file above(bar_pro.tmp) may not exist unless the node has been run for a while. If either file does not show up in the 'tmp' folder, let the node run until 1 or both are created and then execute these commands.
Bookmarks