cinebench 11.5

[BeepBeep2]

FX4100 Windows 7 64-bit LN2 cooling

Unable to match overclocked Deneb on DICE

Did you still have the CB+CBB issue?

[theoldtimer]

Yeah, although the 4100 will keep running run just a little colder than the 8150 did. If I do a normal warm restart it will post at -135/140C or so but in Windows if during a test run if I get the temp below -165C +/- the system locks then after a reset it won’t post until the fluke reads -95C or warmer.

It proceeds something like this during the next post attempt. Temp below -165C +/- the fans run but no video or hard drive activity, next at a temp -130/140C +/- during a post attempt the GPU fan runs at high RPM but no post no video or hard drive activity, lastly at a temp of -95C or warmer it posts normally.

It’s hard to believe that both chips would CB-CBB so I’m wondering if the MB or something else has an issue. I may try it in the AsRock MB to see it the problem persists. That is if I have enough LN2 left to get it cold but if not I don’t plan to buy any more just to find out if it’s the MB.

Oh well it has been interesting none the less.