Originally posted by xgman
I switched to a new A8V board and set it up with the Booster again. I noticed that my 3v rail had been set above 3.5 and my 12v was almost 13, so I turned the 3.3 to 3.4x and the 12 to 12.5 and retried raising the voltage and although now I can run at 2.8 whereas the other board was stuck at 2.6 vddr, higher voltage causes instability or freeze. Is it possible that both my 2x512 EB3700 and my Corsair XL's both can't take more than 2.8-2.9v?

Either that or it is the rare exception that a vddr mod on the A8V will work right above 2.8v. I have heard several posts stating just that on the A8V, the AV8 and even the MSI NF3 board. Maybe, but I need some more statistics on ANYONE run the A8V over 2.8v without freezes and would consider the system stable?
Me again, xgman.......
You have to do the cap-lift mod for the A8V Vddr mod to work. Mines solid as a rock to 3.15v. Unfortunately I wish it'd do 3.5 or so..... what we really need is a Vddr mod like the GB mod, where you connect the 3.3v rail direct to the DIMM power..........

C