***Official***Z68X/P67A-UD7 Club/Discussion/Info**

[andressergio]

Do you still BSOD on idle if you raise the CPU PLL voltage to 1.88v?

my PLL is on 1,86 and i BSOD on IDLE yes...now i went to F3H again

[zsamz_]

my PLL is on 1,86 and i BSOD on IDLE yes...now i went to F3H again

try pll 1.6-1.65

i sold my board so i wont be in this thread again
i finally learned my lesson never again another gigabut board

[the_real_7]

try pll 1.6-1.65

i sold my board so i wont be in this thread again
i finally learned my lesson never again another gigabut board

Have to say the same , Im getting of this bus now . found a mive used for 260.00 , time to put the P67A-UD7 up for sale, was fun when it worked and a great 3dnumber cruncher board, hopefully gigabyte restructures itself

[zsamz_]

Have to say the same , Im getting of this bus now . found a mive used for 260.00 , time to put the P67A-UD7 up for sale, was fun when it worked and a great 3dnumber cruncher board, hopefully gigabyte restructures itself

hope you get a nice MIVE
i bet it does 400mhz more than the gigabut

[the_real_7]

hope you get a nice MIVE
i bet it does 400mhz more than the gigabut

thanks man ! ! ! me to , back to sandy bridge o/c 101 should be fun and now my two 6970 can get some breathing room

[stasio]

try pll 1.6-1.65

i sold my board so i wont be in this thread again
i finally learned my lesson never again another gigabut board

So,where is your words?
Btw,
with latest BIOS,Turbo Boost work as per Intel spec....x38.
http://www.intel.com/support/process...28cs-032279%29



-When memory XMP used,all for cores are x38 (?).
-When BCLK Clock Control "Disabled" it's show 100.3 MHz in CPU-Z.