hello all again today

Here's a quick little update on how things have gone for me with epoxy glue and sanding.

How did it look like now after it had stood for 24 hours of drying time:


I can say that this epoxy glue is so sick tight that there is , because I tried which is to share it when I realized that I had failed to put your stuff that holds the video cards, sound cards and the like :wallbash: . But it did not really get away I tried with that which existed even with chemicals, but it did not come off so I had to drill more holes in the chassis and replacing the graphics card holder.

How it looked after I got your graphics card slot and avoid of any excess glue that was left:


On this picture you can see even my little problem I have but do it later.

I can also say that I am incredibly pleased with myself how awesome I have managed to fit into coherent with each other, the thought that the little extra Bitten I sawed out and put in would be completely skewed to those sides who is already in line with the chassis :dremel:


Here you can see even better how coherent fits in line with each other:


And now for my major, or perhaps a small problem I have:


One sees it not so well but the problem is that I have sanded a little too much on the edge so you can see my graphics card holder and what I wonder is what putty is to be used anyway?
Is there anyone knowledgeable in this area that could explain why I should use such a filler?

In the end I really can think of to keep there and would sit down would be fiber filler, but I can type anything so I ask you for help

/ / Stark.JR