Quote Originally Posted by pociej View Post
Can You help me set it right?
In tab with Flow Sensors all says "0"..

Im still learning the setup myself but you have to assign inputs and outputs in the settings.. its a little complicated but once you do it once its easier for the rest.

You have to make sure you have a unique address id for each PA2 between 50-55 and upgrade PA2 to firmware 1003 for starters.

I guess you will also need to add a page to the interface to view the flowmeter as well as the ones on the default screen are for the AE5 flow meters i think...
As i said its a little complicated.
I learnt how to set up the AE5 by just connecting 1 fan and trying to get it to appear in the page view.

I have 2 flow meters im going to setup myself so later tonight If im successful Ill let you know how I go.
For now im just running the AE5, 6x PA2s and temp/flow sensors externally outside the case until I figure it all out.

(well except for the flow sensors which I fitted a while ago in anticipation of the AE5 but not electrically connected -the cables will reach my desk though due to my setup with case the MM extended ascension horizontal MB layout)

I can even access USB headers on the MB without getting on hand and knee.