ASUS P8P67 Pro/Evo/Deluxe OC discussion thread

[Daddyjaxx]

I do not get the offset. It does not work correctly. If I offset +.08 from 1.27, that should be 1.35 but during linx it jumps to 1.39. The more you offset, the worse it gets. From 1.27 + .20 should be 1.47, but during linx it jumps up to almost 1.6 freaking volts.

I have the latest Beta and I still get the cold double boot.

Trying to find my best 24/7 now at around 1.375v. It will probably be 4.6-4.7. This is the best I have done so far. I tried 5.1 @ 1.5v but it BSOD @ 19 passes of Linx.....so close.

It really doesn't matter. As soon as my 570 blocks get here, the UD7 goes in and the 470's come out so I can have true dual 16x instead of dual 8x.

The SSD is sitting there because hot swap bay 3 had a bad SATA cable. I didn't feel like tearing it apart yet, so that's why you see the red cable. I'm going to move my four SSD's to the bottom two racks and my three normal SATA drives to the hot swap bays.

[IMG][/IMG]
[IMG][/IMG]

[st0ned]

It happens due to LLC set to extreme

[timchaos]

Replacement mobos inc?

http://rss.intel.com/click/~rss-2581...nting-solution

[timchaos]

Replacement mobos inc?

http://rss.intel.com/click/~rss-2581...nting-solution

According to AnandTech, only the 3GB Intel SATA ports are affected. The 6GB Intel ports appear to be unaffected. I assume that means the Marvell ports and Jmicron e-Sata are also unaffected but who knows... In any case, if you have a hard drive on the 3GB Intel port with critical information, might be wise to move it to another port until they sort this all out.

[timchaos]

I've been having an issue with my USB mouse that I believe may be related to the computer going into sleep mode.

The computer comes out of sleep mode fine, except that the mouse sometimes will not respond unless I unplug it from the USB and then plug it back in. After that, sometimes there is unusual behavior with the mouse and clicking, for example, sometimes I can't seem to click the "back" button on my browser even though other things still click.

I believe it started when I plugged in a second monitor as an extended desktop. I tried switching from my Nvidia 480 to an ATI card, but it didn't help resolve the issue.

I'm going to try some more testing by going back to one monitor and or disabling sleep mode to see if the problems happen. I've tried various USB 2.0 and 3.0 ports front and back, but it doesn't seem to make a difference.

Any other ideas?

[timchaos]

I've been having an issue with my USB mouse that I believe may be related to the computer going into sleep mode.

For anyone else having odd mouse-related issues, I can confirm they only occur after sleep. I disabled sleep and rebooted with no further issues. I found a post elsewhere that also said you can disable USB sleep in the power profiles for the same result, but I haven't confirmed that yet.

[Darkstormz]

Using T-Monitor i discovered that my cores will go from x45 -> x16 for about 1/10 of a second, then back to x45. It happends about every 7-8 seconds running LinX... any solution?

Temps are ok, 47c-50c-50c-48c