Thx guys
multiplier and turbo at 56x
vcore at 1.58v - 1.65v
vdimm at 1.85v
PLL,VTT,NB all AUTO
hehehe
believe Dave,you are doing everything right ,your chip sux or need a better cooling
if you are a lucky guy you went to a shop and buy one like that and OC like what i did,
but if you are a unluck guy (like me) you will need to buy the damn lucky
and after weeks of searching i finally found one (or five ,i have five of them to test heheh)
and of course you need a good board ,TP67XE is one of the best P67 plataform
its my second Bro,the first is OK for 53x and hit the wall at 54x,
,but when i was tweaking the second i found the same issue at 54x,but its work at 55x ,56x and maybe 57x,when i set 57x on setup the systems will start to load OS but it will freeze after some seconds
i will re-run the first chip to see if is possible to load at 55x and 56x
yes,
4 cores plus HT is a waste of time for me now,because 5600MHz is stable only for pi and pifast and i will not push the voltages just to get into windows with all cores at these speed
tomorrow will be more exciting ,so stay tuned
5 of than
and i havent checked the temps but its not high temps for sure,im in a cold room (18c)
after tweaking about 30 pieces i got two chips good for 55x(one is dead) ,lots of 54x ,53x and 52x
Bookmarks