MMM
Results 1 to 25 of 7801

Thread: **Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

Threaded View

  1. #11
    Xtreme Member
    Join Date
    Jan 2009
    Posts
    146
    Okay, so here's a new BIOS compilation, this one with updated Realtek PXE Option ROMs and spanning most available BIOS revisions.
    abit IP35 Pro
    BIOSes:
    18 & ZZZ mod
    17 & ZZZ / XXX mods
    16 & ZZZ / XXX mods
    14 & ZZZ / XXX mods
    11
    10
    See http://www.lejabeach.com/ABIT/IP35Pro/ for details of the ZZZ & XXX mods.

    NOTE: I was unable to update BIOS "12" for some reason. My apologies if you require this specific BIOS. I also did not attempt to update any of the beta BIOS versions available on the aforementioned lejabeach site for rather obvious reasons (except 18 and its variants, obviously).

    !!! IF YOU DON'T KNOW WHICH BIOS TO FLASH: Flash 18ZZZ if you have a 45nm processor, or 14ZZZ if you have a 65nm processor for best compatibility.

    Updated with:
    Phoenix AHCI Option ROM 01.06.70 (08-13-2008)
    Intel RAID/AHCI Option ROM 8.5.0.1030
    JMicron JMB363 Option ROM 1.08.01
    Realtek 8110SC PXE Option ROM 1.75c

    Flash using a clean DOS boot floppy or a USB key. Syntax:

    flash.bat

    !!! DISCLAIMER: I AM NOT RESPONSIBLE FOR ANY DAMAGE. FLASH AT YOUR OWN RISK! I HAVE ONLY TESTED BIOS "18ZZZ" PERSONALLY. ONCE AGAIN, FLASH OTHER BIOS VERSIONS AT YOUR OWN RISK. !!!

    Ligushka
    2011-01-20
    Download

    I highly suggest you do not use any BIOS older than 14, but I've included them for posterity. Only BIOS 18ZZZ has been personally tested by myself, but the worst thing that can happen when using an older version would be a conflict between a specific device's option ROM and the BIOS, in which case you simply flash back to the stock BIOS and report back here and I'll try to help you fix it.

    Here is an example of the Realtek PXE ROM's configuration screen which is accessible after pressing Shift+F10 when prompted:



    If you do not require the PXE ROM to display its "press Shift+F10 to configure..." message twice (remember, this board has two GBe LAN ports!) on startup after the Intel AHCI OROM's initialization message, please go to the CMOS setup screen, then Integrated Peripherals, then Onboard PCI Device, and set - Invoke Boot Agent to Disabled for both Network Controller 1 and Network Controller 2.

    If for some reason you require one of the beta BIOSes which are available from the lejabeach website updated, please send me a PM.
    Last edited by Ligushka; 01-20-2011 at 08:36 PM.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •