Gigabyte GA-P67A-UD5 Discussion Thread

[OC Maximus]

I cannot use LL 2 for anything with p67UD5.

Also, I am also stuck at booting at the 52x multi

I think I have tried just about everything -

I have tried cpuv up to 1.62v.
Cpupll as high as 1.88, as low as 1.68v
mem set low or high makes no diff
qpiv from 1.16 to 1.20v
Tried both megahalems and chilled water.

Same here. I can run 100.8x52 or 99.7x53 but no higher. I've tried all kinds of voltages but still seem to smack a wall @ 5.3Ghz. I've tried room temp water and chilled water to no avail. Temps are not the issue. Maybe this can be fixed through a bios update and I hope its not the chip itself. Then again it could be a setting I'm missing to enable or disable. I honestly don't know.

OCM

[GLENBOY]

Same here. I can run 100.8x52 or 99.7x53 but no higher. I've tried all kinds of voltages but still seem to smack a wall @ 5.3Ghz. I've tried room temp water and chilled water to no avail. Temps are not the issue. Maybe this can be fixed through a bios update and I hope its not the chip itself. Then again it could be a setting I'm missing to enable or disable. I honestly don't know.

OCM

same here can boot with 53 multiplier but 54 up no go regardless of volts etc

[dinos22]

Same here. I can run 100.8x52 or 99.7x53 but no higher. I've tried all kinds of voltages but still seem to smack a wall @ 5.3Ghz. I've tried room temp water and chilled water to no avail. Temps are not the issue. Maybe this can be fixed through a bios update and I hope its not the chip itself. Then again it could be a setting I'm missing to enable or disable. I honestly don't know.

OCM

mate this is SB bull OCing for you. i am stuck at 5205 or so