Foxconn BloodRage Shared BIOS Settings

[CobraXP]

CPU & Batch: i7-990x ES
RAM Model: Corsair Dominator GT 1600MHz 6GB
Bios Ver: Quantum BIOS G44

Cooling system on sig

CPU Features
PPM ...............................: Enabled
EIST ..............................: Enabled
CxE................................: Auto
Execute Disable Bit ...............: Disabled
Virtualization.....................: Disabled
CPU Write Bach Cache........: Enabled
Hyper Threading ...................: Enable
Active Processor Cores ............: All
TDC Limit...............................: Enabled
Current TDC Limit....................: 2240
TDP Limit ..............................: Enabled
Current TDP Limit....................: 2400
Current Feedback Override.......: Disabled
CPU QPI Latency ..............: Auto
IOH QPI Latency ...............: Auto
CPU QPI Drive Strength .......: Auto
IOH QPI Drive Strength .......: Auto

Memory Settings
Memory Controller Settings
IMC Configuration .................: Enabled
Channel Congifuration .............: Independent
Channel Interleaving ..............: 6 way
Rank Interleaving .................: 4 way

Memory Timings
Extreme Memory Profile XMP ........: Disabled
Memory Profile Select .............:
DRAM Timing Control ...............: Manual
tCL (CAS Latency) .................: 6T
tRCG (RAS to CAS Delay) ...........: 7T
tRP (RAS Precharge) ...............: 6T
tRAS (Precharge Delay) ............: 16T
CR (Command Rate) .................: 1T
tRFC (Refresh Cycle Time) .........: 59T
tWR (Write Recovery Time) .........: 8T
tWTR (Write to Read Delay) ........: 14T
tRRD (RAS to RAS Delay) ...........: 4T
tRTP (Read to Precharge) ..........: 4T

All Voltage Settings

CPU Voltages
CPU Core Voltage ..................: +310mV (shows 1.440v in windows)
CPU Target Core Voltage ...........: 1.56375V (VID =1.23) windows 1.440v
CPU Vdroop Compensation ...........: disabled
CPU VTT (UnCore) Voltage ..........: +200mV
1.8 PPL Voltage Setting ...........: 1.800V
CPU Clock Amplitude Ctrl ..........: 0.800V

Memory Voltages
DRAM Voltage ......................: 1.66V
DIMM1 Vref CA (Addresses) .........: x 0.500
DIMM1 Vref DQ (Data) ..............: x 0.500
DIMM2 Vref CA (Addresses) .........: x 0.500
DIMM2 Vref DQ (Data) ..............: x 0.500
DIMM3 Vref CA (Addresses) .........: x 0.500
DIMM3 Vref DQ (Data) ..............: x 0.500

Chipset Voltages
X58 IOH Core Voltage .............: 1.18V
X58 IOH VCCA 1.1V ................: 1.108V
X58 IOH VCCA 1.5V ................: 1.506V
ICH10 SB Voltage .................: 1.518V

OC Gear : Skipping this part

CPU Turbo .........................: Disabled
System Turbo ......................: Enabled

Clock Speed Control Center
CPU Bclock (FSB) ................: 200MHz
QPI Link Fast Mode ..............: Enabled
QPI Multiplier ..................: Auto
QPI Target Speed ................: 3605MHz (7.2GT/s)
CPU Core Multiplier .............: x23
CPU Core Target Speed ...........: 4607MHz
CPU Uncore Multiplier ...........: x13
CPU Uncore Target Speed .........: 2606MHz
Memory Bus Multiplier ...........: x8
Memory Bus Target Speed .........: 1604MHZ
PCI Express Bus Clock............: 102MHz