Just got my board last week. Having some crazy issues with my ram on this board. Kingston Hyper-X 2,000mhz 8-8-8-24 t1 3 x 2gb kit. I can get it to run all the way up to 4.2 @ 2,094mhz with 209 bclk. Anything after that it refuses to boot into windows. I'm sure someone has a easy fix for it. And i have tried 103 -110 pci-bus speed also with no results. Here is what i am running right now.

Frequency Control
CPU Clock Ratio ( 20X )
CPU Host Frequency (Mhz) ( 209 )
MCH Strap ( Auto )
CPU Uncore Frequency (Mhz) ( 3860 Mhz { 20X } )
CPU Clock Skew ( 0 ps )
Spread Spectrum ( Disabled )
PCIE Frequency (Mhz) ( 103 )

Memory Feature
Memory Control Settings ( X.M.P 2 )
Memory Control Setting ( Enabled )
Memory Frequency ( Auto)
Channel Interleave Setting ( 6 Way )
Rank Interleave Setting ( 4 Way )
Memory Low Gap ( 2.5 )

Voltage Control
EVGA VDroop Control ( Without VDroop )
CPU VCore ( 1.247 )
CPU VTT Voltage ( +300 )
CPU PLL VCore ( 1.425 )
DIMM Voltage ( 1.65 )
DIMM DQ Vref ( +0mV )
QPI PLL VCore ( 1.500)
IOH VCore ( AUTO )
IOH/ICH I/O Voltage ( AUTO )
ICH VCore ( 1.050 )
VTT PWM Frequency ( 250KHz )
CPU PWM Frequency ( 940KHz )
CPU Impedance (Less)
QPI Signal Comp (Less)
CPU Feature
Intel SpeedStep ( Disabled )
Turbo Mode Function ( Disabled )
CxE Function ( Disabled )
Execute Disable Bit ( Disabled )
Virtualization Technology ( Disabled )
Intel HT Technology ( Disabled )
Active Processor Cores ( All )
QPI Control Settings ( Enabled )
QPI Link Fast Mode ( Enabled )
QPI Frequency Selection ( 4.8 GT/s )
OC Recovery ( Enabled )

As i can't find a good stop for the ram. as it is either 1866mhz or 2,133+ on up. My R2E was a little easier on the ram setting up. So i'm sure it is something simple that needs to be changed. As i would like to show my old R2e up as it hit 4.6ghz with ease. Now i'm changing stuff right and left in the 760 bios. Thanks