So here is the update:

I removed the HDD bays. Like I said earlier this was the first time that I actually used a power drill. Anyway, here are the screws that I will be using as much as I can in the build. Nice screws and most of them are black.



Here are the screws being used:



And here is the HDD bay removed. And the filter I showed you guys earlier.



Anyway got a little mroe work done. Sleeded the Fan controller, all the fans and the 24 pin. Expect photos soon. I also got a lot of my stuff for the build. FINALLY....

On another note, I was not able to fit the rad with the barbs in front, as the tubing was fouling with the DVD rom drive. Also I needed to mount my res up there and was using the holes that are there in the 5 1/4" bays. So I have bought a new external USB DVD drive, which I will keep on my desk. This will make it more accessible as well as give me the space to mount the rad and res easily.

This is what I have bought:

http://go.iomega.com/en/products/mul.../?partner=4750

Since I barely use the DVD drive anyway, I dont think it will be too much of a hassle.

Sorry there are no pics, but will try and get something up this weekend. And just a heads up for guys wanting to water cool, getting fans to fit on top of the case, pulling air thru the rad is a pain, as the top has only four fan holes, which are divided between two fan spots. so two holes per fan for two fans and no holes for the third. Now what happens is that the fans when attached are uneven and therefore loose a lot of the pressure and airflow that is required. So luckily I had enough space to fit the fans inside, though that was not the original plan. And am lucky it fit. I thought I was screwed for a moment.