New LSI 9200 series controllers: 6Gb/s, 2.88 GB/s seq. reads, 1.87 GB/s seq. writes

[trans am]

only way is disconnect everything meaning any drives attached to sata board headers. you can leave your raid set in tact that you made on the lsi card. it shouldnt matter that they are on. set your cmos jumper and clear it. get into mobo bios and go to boot priority menu. if you dont see the raid as the 1st hit escape and go below to the hdd priority. make sure the lsi raid is set to the 1st one and disable anything beneath since you have no drives connected except the card you should see only the raid card. hit f10 and save and restart if you see the lsi bullcrap going then you are good. just tap the ctrl and H together and tap them together like you are hitting the snare and the floor tom together. see if it goes.

what board are you on mk? is it the ud7? I see that board has 3 x x16 slots and one at the bottom that is prob x16 at 4x. which slots are u using exactly? what slot is your vga and lsi using? from the top 1 being the top x16 lets say 1 2 3 4

screw the links on google. if paul and I are available you cant get better tech support than this. and dont waste your time with lsi tech support. who do you think they get their support from?