3.3v read point

[Swindler]

i have antec 550w tc psu ant abit nf7-s no vdimm mod...
i try increase 3.3 by cantec control panel and read on vdimm mosfet.. no difference higher or lower ai set multimeter show 3.25 way??? vdimm is 2,9 in bios and 3.1v real with tictac bios... vdimm mod soon but not now..searching soldering-iron..

[Hell-Fire]

Where are you checking your 3.3v reading from? You should check it either in the ATC connector or on the flat 5 slot power connector that has 2 Black, 2 Orange, and 1 Red wire running into.

Obviously the Orange is the 3.3v rail.

Regardless, the TC550 does not really allow high adjustments. You should consider the 3.3v rail mod. Many guides are listed in this forum.

[reject]

i thought it went to 3.6v? thats very nice for unmodded.