I need some godly evaporator advice

[kayl]

someone i dont think that block design would work very well.
if you look at the maze design your ment to get the Freon to travel over a long distance, ie into the centre of the block (bottom layer), progress to the outside, then into the second layer outside inwards exiting again, normally we tune to a given load, this way it gets a good chance to boil off and remove heat.
in your block it enters, then would find the shortest path out and wouldnt hold much of a heat load.


If you don’t have access to a mill anymore but you can get you hands on some copper you could try something like this, this is one of lardass evap’s he made, l plan to do something similar when I get some copper (not sure where)

[kayl]

or this one, (bercuits block) something along this line you get the idear, mainly the idea of drilling the copper in a way to get the maze effect