for some reason my LinX keeps stoping after the first test to what seems like ghost errors...
i7 980x @ 4.5ghz (39x115) w/ 1.4125v, qpi - 1.475v (12gb memory), PLL - 1.61v, dram - 1.643v
data link @ 2777mhz and uncore 2425mhz (testing with my G.skills, not Dominators @ 1613mhz 7-8-7-24-72-2N)
every other stability tests i have go through fine but linx just hangs...
it's not temp either cause i'm averaging around 68*c on water..
but every test done (which i did atleast 20 single tests to get an average), it averaged beteen 58 and 62 Gflops w/ hyperthreading enabled... then again i'm not sure how much that counts cause it was 20 single tests with 1 lap each, not 1 test with 20 laps.
EDIT: one thing i think could benifit this program... and just about any other stability program period is if it freakin tells you what the error is or is caused by... LinX will not finish completely stable for me even on 100% stock clocking. i then set it to ignore errors... test completes and says "completed with errors" but doesn't tell you how many errors there are or whether or not they are heat errors or critical voltage errors or anything...
at the same time Vantage tells you your gflops anyway in it's CPU tests. test 1 is in Mflops and test 2 is in Gflops. i can further confirm this by looking at the vantage test as it's going, test 1 i average around 5600-5900 Mflops and test 2 average around 57-58 Gflops.
Reply With Quote
Bookmarks