3x2GB Super Talent 2200C8 @DDR3-2392Mhz 8-8-8-24 1.7v

[BeepBeep2]

Really bad board, only 1760 6-6-6, what a shame.



I'm kidding right.

I can only hit 1760 6-6-6 with 1.75v

[Barr3l Rid3r]

I can only hit 1760 6-6-6 with 1.75v

I've runned everest @ 1840Mhz 6-7-6 today w/ 1.75v... but when I saved the SS the computer restarts..

[BeepBeep2]

I've runned everest @ 1840Mhz 6-7-6 today w/ 1.75v... but when I saved the SS the computer restarts..

I can't boot 1800 6-7-6 nomatter what voltage I use...that might tell you a bit.

I did a TON of subs tweaking to get where I was at for that review.

[Barr3l Rid3r]

I can't boot 1800 6-7-6 nomatter what voltage I use...that might tell you a bit.

I did a TON of subs tweaking to get where I was at for that review.

can u pass me your final settings?

gigabyte 790fxt-ud5p has only a few settings.

I'm having trouble to make it stable at 1800 C7

[BeepBeep2]

can u pass me your final settings?

gigabyte 790fxt-ud5p has only a few settings.

I'm having trouble to make it stable at 1800 C7

I ended up ditching the tweaking.

Your board is flaky...it's definately stable at 1800 C7 but its your board's fault.

My 890GX board had problems booting over 1800. If you boot at 1700 and inch up to 1800+ if will be fine.

If will POST one time, boot another time, be stable the third time, become unstable the fourth. You can't help it.

My 890GX board had a cap at 1880 Mhz as well, with my Deneb CPU. My ASUS board is stable as a rock at 1900. Go figure.