When u run prime95 at what CPU temp should u stop it I have nearly hi 80 degrees.Can't beleave at 1.37 vcore I'm getting such high temps and I'm watercooled.What are your temps under 100% load in prime anyone else seeing these babies running that hot.I mean watercooled could it be my watercooling setup has degraded had it 2 years. Swift CPU block Laing pump and 360 rad .
Last edited by kullymontana; 06-17-2010 at 04:11 PM.
MB Name:Rampage III Extreme
BIOS Version : 0602
CPU Name :Intel(R) Core(TM) i7 CPU X 980 @ 3.33GHz
Memory information:CMG6GX3M3A2000C8 - 6GB (3x2GB) Corsair Dominator GT, DDR3 PC3-16000(2000), CAS 8-8-8-24, DHX, XMP, DF, 1.65V
OS information :Windows 7 Ultimate 64 Bit version
1200 watt psu tough power
2 280gtx sli
For some reason, I can't seem to get over 225 BCLK.
Can anyone help? My dice pot arrived today and I'll be benching it tomorrow.
Here's my template.
Code:Target CPU Frequency 3300MHz Target DRAM Frequency 1323MHz LN2 Mode []*** QPI Loadline Calibration []*** Sync Mode [Disabled] AI Overclock Tuner [Manual] OC From CPU level Up [Auto] CPU Ratio Setting [15] CPU Turbo Power Limit [Disabled] >CPU Configuration---------------------------- CPU Ratio Setting [15.0] C1E Support [Disabled] Hardware Prefetcher [Enabled] Adjacent Cache Line Prefetcher [Enabled] Intel(R) Virtualiyation Tech [Enabled] CPU TM Function [Enabled] Execute Disable Bit [Enabled] Intel(R) HT Technology [Enabled] Active Processor Cores [All] A20M [Disabled] Intel(R) SpeedStep(TM) Tech [Disabled] Intel(R) C-STATE Tech [Disabled] C State package limit setting [] ---------------------------------------------- BCLK Frequency [220] PCIE Frequency [110] DRAM Frequency [DDR3-1323MHz] UCLK Frequency [2647MHz] QPI Link Data Rate [Slow Mode] Memory Configuration Protect [Disabled] >DRAM Timing Control-------------------------- CAS# Latency [7 DRAM CLock] RAS# to CAS# Delay [7 DRAM CLock] RAS# PRE Time [7 DRAM CLock] RAS# ACT Time [21 DRAM CLock] RAS# to RAS# Delay [Auto] REF Cycle Time [Auto] WRITE Recovery Time [Auto] READ to PRE Time [Auto] FOUR ACT WIN Time [Auto] Back-To-BackCAS# Delay [Auto] Timing Mode [1N] Round Trip Latency on CHA [Auto] Round Trip Latency on CHB [Auto] Round Trip Latency on CHC [Auto] WRITE To READ Delay(DD) [Auto] WRITE To READ Delay(DR) [Auto] WRITE To READ Delay(SR) [Auto] READ To WRITE Delay(DD) [Auto] READ To WRITE Delay(DR) [Auto] READ To WRITE Delay(SR) [Auto] READ To READ Delay(DD) [Auto] READ To READ Delay(DR) [Auto] READ To READ Delay(SR) [Auto] WRITE To WRITE Delay(DD) [Auto] WRITE To WRITE Delay(DR) [Auto] WRITE To WRITE Delay(SR) [Auto] ---------------------------------------------- CPU Differential Amplitude [Auto] CPU Clock Skew [Auto] IOH Clock Skew [Auto] ------------ Extreme Engine Digi+ ------------ Digi+ PWR Mode [X-Power] PWR Volt. Control [Auto] Load-Line Calibration [50% Calibration] CPU Voltege OCP [Enabled] CPU PWM Frequency [Auto] Extreme OV [Disabled] Extreme OC [Auto] CPU Voltage [1.45625] CPU PLL Voltage [1.89475] QPI/DRAM Core Voltage [1.40000] DRAM Bus Voltage [1.66950] >DRAM REF Voltages---------------------------- DRAM DATA REF Voltage on CHA [Auto] DRAM CTRL REF Voltage on CHA [Auto] DRAM DATA REF Voltage on CHB [Auto] DRAM CTRL REF Voltage on CHB [Auto] DRAM DATA REF Voltage on CHC [Auto] DRAM CTRL REF Voltage on CHC [Auto] ---------------------------------------------- IOH Voltage [1.21900] IOH PCIE Voltage [1.51050] ICH Voltage [1.21900] ICH PCIE Voltage [1.51050] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum [Auto] DRAM Spread Spectrum [Auto] ***on-board jumper dependant
Reply With Quote
Bookmarks