Check out my 2000MHz memory 24/7 settings for hot summer daysOriginally Posted by KaRLiToS
Hope it might help.
Code:Target CPU Frequency 4200MHz Target DRAM Frequency 2005MHz LN2 Mode: Disabled*** QPI Loadline Calibration: Enabled*** Sync Mode [Enabled] AI Overclock Tuner [Manual] OC From CPU level Up [Auto] CPU Ratio Setting [21.0] CPU Turbo Power Limit [Disabled] >CPU Configuration---------------------------- CPU Ratio Setting [21.0] C1E Support [Enabled] Hardware Prefetcher [Enabled] Adjacent Cache Line Prefetcher [Enabled] Intel(R) Virtualiyation Tech [Enabled] CPU TM Function [Disabled] Execute Disable Bit [Enabled] Intel(R) HT Technology [Enabled] Active Processor Cores [All] A20M [Disabled] Intel(R) SpeedStep(TM) Tech [Enabled] Intel(R) C-STATE Tech [Enabled] C State package limit setting [Auto] ---------------------------------------------- BCLK Frequency [200] PCIE Frequency [100] DRAM Frequency [2005] UCLK Frequency [4009] QPI Link Data Rate [7218] Memory Configuration Protect [Disabled] >DRAM Timing Control-------------------------- CAS# Latency 7 [7] RAS# to CAS# Delay 9 [9] RAS# PRE Time 7 [7] RAS# ACT Time 21 [21] RAS# to RAS# Delay 6 [Auto] REF Cycle Time 88 [88] WRITE Recovery Time 12 [11] READ to PRE Time 7 [Auto] FOUR ACT WIN Time 28 [Auto] Back-To-BackCAS# Delay 0 [Auto] Timing Mode 1N [1N] Round Trip Latency on CHA 59 [59] Round Trip Latency on CHB 61 [61] Round Trip Latency on CHC 62 [62] WRITE To READ Delay(DD) 8 [Auto] WRITE To READ Delay(DR) 8 [Auto] WRITE To READ Delay(SR) 19 [Auto] READ To WRITE Delay(DD) 8 [Auto] READ To WRITE Delay(DR) 8 [Auto] READ To WRITE Delay(SR) 8 [Auto] READ To READ Delay(DD) 7 [Auto] READ To READ Delay(DR) 6 [Auto] READ To READ Delay(SR) 4 [Auto] WRITE To WRITE Delay(DD) 7 [Auto] WRITE To WRITE Delay(DR) 7 [Auto] WRITE To WRITE Delay(SR) 4 [Auto] ---------------------------------------------- CPU Differential Amplitude [Auto] CPU Clock Skew [Auto] IOH Clock Skew [Auto] ------------ Extreme Engine Digi+ ------------ Digi+ PWR Mode [T-Balanced] PWR Volt. Control [Auto] Load-Line Calibration [Full] CPU Voltege OCP [Enabled] CPU PWM Frequency [1000kHz] Extreme OV [Disabled] Extreme OC [Auto] CPU Voltage 1.303 [1.31250] CPU PLL Voltage 1.812 [Auto] QPI/DRAM Core Voltage 1.396 [1.41250] DRAM Bus Voltage 1.654 [Auto] >DRAM REF Voltages---------------------------- DRAM DATA REF Voltage on CHA [Auto] DRAM CTRL REF Voltage on CHA [Auto] DRAM DATA REF Voltage on CHB [Auto] DRAM CTRL REF Voltage on CHB [Auto] DRAM DATA REF Voltage on CHC [Auto] DRAM CTRL REF Voltage on CHC [Auto] ---------------------------------------------- IOH Voltage 1.244 [Auto] IOH PCIE Voltage 1.508 [Auto] ICH Voltage 1.111 [Auto] ICH PCIE Voltage [Auto] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum [Disabled] DRAM Spread Spectrum [Disabled] ***on-board jumper dependant
Reply With Quote
Bookmarks