Got some stuff in today.....EK-DCP 4.0 and Res, EK Supreme HF, and XSPC 360

[Major]

Just an update. I finally got everything to add a Rad in the bottom of the case.
RX120, 2x GT 1850rpm, and some right angle fittings for the pumps.

I'll post some photos after I get it all set up (I'm sure I'll stay up late messing with it! lol)

Here is the last temp test I did after I reversed the fans in my case. All are blowing out now except the ones on the RX360 in the top which are drawing cold in in through the rad.
The RX120 will go in the bottom of the case drawing cold air in through it as well. I'll post some results after I get it all set up at the same settings below for comparison.



BTW, I have some money to put into my system next week. Looking at going with a 980x on the RX360 and RX120 with the same setup and adding a Nvidia 480 to a separate loop with 2x Swiftech QP120's one in the front drive bay and the other in the rear of the case. I may have the money to go with some DDC 3.25 pumps and dual tops too.

[Waterlogged]

I may have the money to go with some DDC 3.25 pumps and dual tops too.

[Major]

Love it!!!

I came into some money since I started this project. Even though my funds are far from unlimited I do have enough to upgrade a few things now